Home / Lithium & DC-DC

Lithium Batteries & DC-DC Chargers

LTO lithium batteries, Toshiba SCiB cell banks, 15.4V step-up DC-DC chargers and 500A relays – built to work with our high output alternators.

DC-DC converters

15.4V step-up DC-DC chargers

Purpose-built for charging 6S LTO batteries, including our 6S LTO banks and prebuilt 6S LTO battery systems. Designed for vehicles where you can't fit an aftermarket alternator, allowing you to run a dedicated 15.4V secondary charge system while keeping the factory charging system untouched.

60amp 15.4v Step-Up DC-DC Converter60A

60amp 15.4v Step-Up DC-DC Converter

  • Suitable for systems up to 3kW
  • ~80A input fuse

£189.99

View & order
100amp 15.4v Step-Up DC-DC Converter100A

100amp 15.4v Step-Up DC-DC Converter

  • Suitable for systems up to 5kW
  • ~135A input fuse

£269.99

View & order
130amp 15.4v Step-Up DC-DC Converter130A

130amp 15.4v Step-Up DC-DC Converter

  • Suitable for systems up to 7kW
  • ~175A input fuse

£349.99

View & order

Operating characteristics

  • Input: 10–14.6V
  • Output: 15.4V (ideal for 6S LTO)
  • Boost remains active between input voltage and the 15.4V target
  • As output voltage approaches input voltage, current increases up to the capability of the vehicle's input charging system
  • Units can be run in parallel for larger systems

Due to their solid-state design, these chargers respond to dynamic current demand significantly faster than an alternator. They cannot be directly compared to alternator output – voltage regulation and transient response under heavy load are far superior, making them ideal for high-demand 6S LTO setups.

Installation requirements

  • Input current requirement is approximately 35% higher than rated output (e.g. 130A output needs approx. 175A input supply)
  • Fuse at 35% above rated output current: 60A → ~80A, 100A → ~135A, 130A → ~175A
  • Minimum 0 AWG (50mm²) cable on both input and output
  • Must be used with a 500A relay on the input side (can be supplied)

Proper wiring, protection and installation are critical for safe and reliable operation. 12 months warranty and full installation support – message us with your alternator rating and 6S LTO setup for compatibility confirmation.

Batteries

Lithium batteries & relays

20/40AH D2U LTO Lithium BatteryLTO

20/40AH D2U LTO Lithium Battery

  • Built to order & ready to use, balancer included
  • 1200 CCA @ 0°C, weighs just 5kg
  • 14.8–15.5V compatible
  • Tested up to 11kW (correct setup required)
  • Build time 3–4 weeks, 12 months warranty
Options & prices
20AH Lithium Battery£399.99
40AH Lithium Battery£649.99
500A Relay£79.99
Battery Support£15.99

From£15.99

View & order
Toshiba SCiB 20Ah Cells - 15v BankSCiB

Toshiba SCiB 20Ah Cells - 15v Bank

  • Bank of 6 brand-new Toshiba SCiB cells
  • Capacity tested above 20Ah, link bars supplied
  • 5–6kW per bank with a 200A+ high output alternator
  • Custom busbars for multi-bank setups: £30 per bank

£250.00

View & order
500 Amp Relay500A

500 Amp Relay

  • For proper secondary battery installation
  • Required on the input side of our DC-DC chargers

£79.99

View & order

LTO battery: installation & charging

  • Use as a second battery with a 500A relay or suitable isolator, or replace your stock battery entirely
  • Designed for interior / boot installations – not recommended for the engine bay
  • Must be securely mounted and protected from moisture and excessive heat
  • Recommended operating range 14.8–15.5V; vehicle charging system must be healthy and properly regulated

Incorrect wiring, over-voltage, under-voltage or charging system faults can damage lithium batteries and will void warranty. Power capability depends on overall system design, wiring quality, alternator output and tuning.

Lightweight power

At 5kg, the 20Ah LTO battery is a massive weight saving compared with a typical 100Ah AGM lead-acid battery at 25–30kg. To get similar usable high-discharge performance from AGM you would typically need at least three 100Ah AGM batteries – 75–90kg versus 5kg.

Can be built to higher capacity and voltage if required. For custom capacity, higher-voltage builds, mounting kits or relay packages, contact us directly.

Get in touch

Talk to us about your build

If you don't find what you are looking for amongst our collection, send us a message and you can be sure we will find you a solution.